Blue Sensor Gold For Blue Connect

Official sensor replacement for Blue Connect smart water analyzer. Available in two versions: Pt sensor (platinum probe) and Au sensor (gold probe), recommended for pools with salt chlorinator.

Features:

– Original piece for the replacement of the Blue Connect probe.
– Special for pools with salt chlorinator.
– The probe needs to be replaced approximately every two years.
– To ensure maximum longevity of the probe, keep it for as long as possible in a humid environment.
– If you take the device out of the water, you must screw it to the storage cap with KCl (saturated potassium chloride), pH4 or, as a last resort, pool water.

Steps to follow in order to replace the probe:
– In “Settings“ » ”Blue Connect”, press “Probe replacement“. Slightly and gently pull on the four plastic tips of the probe. Be sure to remove the seal and discard it. It could be stuck inside.
– Take out Blue Connect from the water. Wipe the device and start the procedure in a dry, clean place.
– Remove the usage cap and nut. If you struggle to unscrew the nut, use adjustable pliers by placing them on this exact spot Scan the QR code of the new probe.
– Remove the protective cap. Be careful not to drop the probe as it is a very fragile item. Place the new seal supplied with the replacement on the new probe. Insert the probe and turn it until it is placed correctly. Three beeps are emitted within 15 seconds
– Screw the nut firmly onto the device. Feel free to use adjustable pliers to tighten it properly.
– Then, place the usage cap and place Blue Connect back in the water.